Installing the pump or motor
The unit is set in place and connected so it can lift water to an overhead or underground tank.
We install and connect water pumps and motors that lift water to overhead or underground tanks, in Anna Nagar and nearby areas.
A pump or motor does the lifting when water has to reach a tank on the roof or a sump below ground.
Motor and pump fitting is the installation and connection of water pumps and motors that lift water to overhead or underground tanks.
A pump that is too small for the tank height or the flow needed will run hard and fill slowly.
The main parts of a motor and pump fitting, from the connection to the final test.
We do this work for homeowners and for shops and offices in Anna Nagar, Adyar, T Nagar, Velachery and nearby areas.
Call us to talk through your job.
It covers installing and connecting the pump or motor, wiring it to a suitable power point, aligning it with the pipework and testing that water flows correctly.
The pump has to suit the height of the tank and the flow you need.
Yes. Motor and pump fitting covers pumps that lift water to overhead or underground tanks.
Motor and pump fitting is the careful installation of a pump or motor that lifts water to where it is needed.
The unit is set in place and connected so it can lift water to an overhead or underground tank.
The motor is wired to a suitable power point so it runs safely and reliably from the start.
The pump is lined up with the existing pipes so water passes through without strain or leaks at the joints.
The pump is matched to the tank height and the flow you need, so it fills the tank steadily instead of running hard.
Once fitted, the system is tested to confirm that water flows correctly to the tank.
A few practical points help the job go smoothly.
Having the height of the overhead or underground tank ready helps size the right pump for your needs.
Note where the nearest suitable power point is, since the motor is wired to it during installation.
Ask for the water flow to be tested after fitting, so you know it reaches the tank correctly.